03523107_ed17
EN-1
EN
Product Safety Information
Intended Use:
These Air Impact Wrenches are designed to remove and install threaded fasteners requiring high
torque.
WARNING
●
Failure to observe the following warnings, and to avoid these potentially hazardous
situations, could result in death or serious injury.
●
This tool is designed to be operated by a minimum of two persons.
For additional information refer to Product Safety Information Manual Form 04580916.
Manuals can be downloaded from ingersollrand.com
Product Specifications
Model
Drive
Impacts
per min.
Recommended
Torque Range
Sound Level dB(A)
(ISO15744)
Vibration (m/s²)
(ISO28927)
Type
in.
ft-lb (Nm)
† Pressure (L
p
) ‡ Power (L
w
) Level
*K
588A1
Square 2-1/2" 550
12000-25000
(16270-33900)
110.0
121.0
--
--
588A1-EU
† K
pA
= 3dB measurement uncertainty
‡ K
wA
= 3dB measurement uncertainty
*K= Vibration measurement uncertainty
WARNING
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16606303 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
7.
Coupling
2. Regulator
8.
Safety Air Fuse
3. Lubricator
9.
Oil
4. Emergency shut-off valve
10. Oil - fill oil chamber
5. Hose diameter
11. Grease - through fitting
6. Thread size
12. Grease - through fitting
