25
5.
Remove the three capscrews (101) and washers (102) that
fasten the stationary end of the brake band to the brake bracket
(106).
NOTICE
Make sure to remove and retain
the three tubular steel spacers
(103) and the rubber spacer (105).
(Dwg. MHP0986)
6.
Using a cloth strap wrench, turn the cylinder assembly
counterclockwise to loosen and remove it from the winch.
(Dwg. MHP0923)
7.
Using a 10 mm allen wrench, loosen and remove the two long
and two short capscrews (107 and 112) that fasten the brake
bracket to the winch upright. Remove the brake bracket from
the side frame.
NOTICE
A 3/8 inch allen wrench may be
needed to remove the two socket
head capscrews closest to the
brake surface. The 3/8 inch allen wrench has enough
clearance to turn near the drum flange.
(Dwg. MHP0979)
8.
Pull the plunger (114) out of the brake bracket.
NOTICE
Make sure to remove and retain
the small spring (113) that rests
behind the plunger.
(Dwg. MHP0977)
9.
Carefully spread apart the ends of the brake band and move it
off the brake surface and onto the winch drum barrel diameter.
10. Carefully spread the ends of the brake band apart far enough to
clear the winch drum barrel diameter, and pull the brake band
off the drum. Do not damage the threads of the adjustment bolt
by dragging the bolt over the winch drum.
(Dwg. MHP1097)
Section 3
Tubular
Spacer
Rubber
Spacer
Remove the Capscrews
holding the Brake Bracket
to the Winch Upright.
Plunger
Spring
Summary of Contents for FA5A
