ENGLISH
Gear Housing
MLK Hoists
No additional lubrication is required for the gearing.
HLK Hoists
Remove the oil level plug from the side of the housing. If the oil level is below the piped tapped hole,
remove the vent plug and add a sufficient amount of
Ingersoll-Rand
No. 62 oil (Texaco Meropa
No. 3 or Texaco Meropa No. 220). Replace the oil level plug and vent plug.
PARTS ORDERING INFORMATION
The use of replacement parts other than
Ingersoll-Rand
Material Handling may invalidate the
Company’s warranty. For prompt service and genuine
Ingersoll-Rand
Material Handling parts
provide your nearest Distributor with the following:
1.
Complete model number as it appears on the nameplate.
2.
Part number and part name as shown in parts manual.
3.
Quantity required.
Return Goods Policy
Ingersoll-Rand
will not accept any returned goods for warranty or service work unless prior
arrangements have been made and written authorization has been provided from the location where
the goods were purchased.
Hoists returned with opened, bent or twisted hooks, or without chain and hooks, will not be repaired
or replaced under warranty.
Disposal
When the life of the hoist has expired, it is recommended that the hoist be disassembled, degreased
and parts separated by material so that they can be recycled.
SERVICE AND MAINTENANCE
Hoist repair and maintenance should only be carried out by an Authorized Service Repair Center.
Contact your nearest
Ingersoll-Rand
office for details.
The original language of this manual is English.
Hoist Parts and Maintenance information is available in English by requesting the following
publications:
MLK Hoist Parts, Operation and Maintenance Manual Form Number P6554
HLK Hoist Parts, Operation and Maintenance Manual Form Number P6587
14
