47631617001_ed5
EN-2
EN
0
2 (3)
4 (5)
6 (8)
8 (11)
10 (14)
Forward Torque
ft-lb (Nm)
Figure A Hand-tight
M6
M8
M10 M12
Bolt Size
35 (50)
50 (68)
65 (88)
80 (108)
95 (129)
110 (150)
Forward Torque
ft-lb (Nm)
Figure B Wrench-tight
M10 M12 M14 M16
Bolt Size
NOTICE
Torque values shown in Figures A and B are approximate. Actual torque can be effected by the application and may vary from the values
shown in the graph.
Lubrication
Remove hammer case to apply lubrication on the anvil, impact mechanism assembly and gears. Apply grease evenly and sparingly. An excessive
accumulation of grease will result in sluggish operation. See drawing 48380273 and table below. Maintenance frequency is shown in a circular arrow
and defined as h=hours, d=days, and m=months of actual use.
1
8h
1
8h
2
8h
1
8h
(Dwg. 48380273)
1
2
IR#
IR#
105
67
Task Light
CAUTION
●
Task Light is not user serviceable. Repair should only be carried out by an Ingersoll Rand authorized service center. User service may
result in electric shock, fire and or serious personal Injury.
●
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation
exposure.
●
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Adjust Brightness and Flashlight Mode
1. To set task light, position directional switch to neutral.
2. Pull trigger to cycle through brightness options or to turn off light.
3. Position directional switch to Forward or Reverse to save desired brightness setting and begin tool use.
Refer to illustration #2 on page 32.
NOTICE
While in neutral, tool will remain in task light mode for 10 minutes.
Parts and Maintenance
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand office or distributor.
Summary of Contents for IQV20 W7002 Series
