The FISC CDM User’s Manual
4
I
I
n
n
s
s
t
t
a
a
l
l
l
l
i
i
n
n
g
g
F
F
I
I
S
S
C
C
C
C
D
D
M
M
i
i
n
n
t
t
o
o
a
a
T
T
o
o
w
w
e
e
r
r
Since FISC CDM is equipped with 4 IDE channels that can host 8
EIDE HD or CD-ROM drives, you might use 9-bay tower cases. If
you purchase a FISC CDM Tower, the FISC CDM controller has
already been properly pre-installed into the bay in the center of the
tower while the IDE flat cables have also been plugged onto the
FISC CDM controller. All you have to do is to connect your EIDE
HD or CD-ROM drives to the IDE cables. Please refer to page 8
—
Connecting CD-ROM Drives
.
For instructions on installing the FISC CDM into a third party 9-bay
tower case, please refer to the power and fan requirements stated in
Appendix A —
Technical Specifications
and the following
installation steps.
Caution!
In order to avoid the possible risk of electrical shock
and any other injury, please disconnect the power
before installation.
1.
Remove the screws at the rear of the tower that secure the
cover of the tower to the tower chassis. Remove the cover
of the tower.
2.
Slide the FISC CDM controller into the fifth bay (in the
center of the tower). Refer to the following illustration.
FISC CDM
Figure 2-1: Installing the FISC CDM Controller
