The FISC CDM User’s Manual
6
Network
Connection
Board
UTP
Cable
Figure 2-3: Connecting the Network Connection Board
The ideal air flow circulation of a FISC CDM tower is
through the front of the tower to the rear. Therefore,
the front panel of FISC CDM must not be blocked or
shielded. If you are using a tower with a front door,
the tower must have ventilation holes on both sides of
the door.
S
S
I
I
M
M
M
M
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
a
a
n
n
d
d
R
R
e
e
m
m
o
o
v
v
a
a
l
l
In addition to the on-board 8MB of RAM, the FISC CDM comes
with two SIMM sockets, which allow you to increase the total
memory capacity. Use standard 8MB, 16MB or 32MB EDO SIMM
modules to upgrade the memory of the FISC CDM.
Installing a SIMM
1.
Remove the four screws that secure the top cover of the
FISC CDM. Remove the top cover.
2.
Locate the 72-pin SIMM sockets.
3.
Firmly insert the module into the socket at an angle as in
Figure 2-4
, #1. Make sure that the SIMM is seated evenly.
4.
Press the top edge of the SIMM module in the direction of
#2 in the illustration until the retaining latches click into
place. Refer to the following illustration:
