31
on. If the authentication mode is not automatic, but PAP
or CHAP, use only PAP or CHAP authentication to dial.
Network dial number
The default parameter is * 99 *** 1#, which is required
by mobile network operators.
PIN
PIN (Personal Identification Number) refers to the
Personal Identification password of the SIM card. When
the SIM card is enabled for PIN verification, does it fill in
the corresponding PIN of the SIM card. This parameter
is required for mobile network operators.
Default carrier APN This parameter is provided by the carrier.
The default host setting is a function for special data transmission required
by some carriers, which generally does not need configuration. If configuration
is required, please inquire from your carrier.
5. Configuration of Vehicle Diagnostic
Interface
The on-board diagnostic interface is the South interface of the tracker and the
configuration option of the protocol.
5.1 Configure ODB Interface
In the configuration tool, select OBD as the diagnostic protocol. The ODB
protocol is the CAN2 interface and J1708 interface of the vehicle tracker.
Parameter
Description
Others
J1939/J1979
ODB CAN2 interface protocol,
corresponding to physical layer PIN
CAN_2L(PIN 12) and CAN_2H(PIN
25)
OBD default configuration
Summary of Contents for VT300 Series
