67
When a prompt box says "Will switch to the new version after restarting
VT310", new firmware has been imported successfully. Click "Restart" to
upgrade the firmware.
Note: After the device is upgraded, restart the device and then configure it.
7.2 Restore Factory Settings of FlexAPI
Go to Maintenance >> FlexAPI restore factory settings to reset FlexAPI
settings.
Summary of Contents for VT300 Series
