18
IDS 805 User Manual 700-266-01C Issued March 2009
4.
The ARMED and READY indicators will begin to flash simultaneously indicating that the correct
master code was entered. If an invalid code was entered, the keypad buzzer will beep three
times, and exit the programming mode.
5.
Enter the
[USER CODE NUMBER]
you wish to change (1-15) followed by the
[*]
key.
6.
Enter the new 4 digit
[USER CODE]
and press the
[*]
key.
7.
Repeat steps 5-6 to enter or change other user codes.
8.
Once all the codes are programmed, press the
[#]
key to exit.
11.2 Deleting User Codes
Follow steps 1-5 of the previous procedure but only press the
[*]
key in step 6. That particular code will
be deleted.
11.3 Maid’s Code
The maid’s code (user 14) may be used to limit access to the premises. The maid’s code will only disarm
the system if the same code was used for arming. If armed with a code other than a maid’s code, the
system will view an attempt to disarm with the maid’s code as an invalid entry. Any valid user code will
disarm the system if it has been armed with the maid’s code.
EXAMPLE:
If a maid is expected on a Monday, arming the system on a Monday morning using the maid’s code will
allow the maid to disarm the system. On days that any other user code (i.e. not a maid’s code) has been
used to arm the system entering the maid’s code will not disarm the system.
12. Stay Zones
Stay zones are those zones which are bypassed automatically when the system is STAY ARMED. To
avoid triggering the alarm, zones such as bedrooms, or other areas which require access, must be
bypassed. Stay zones need only be programmed once. Each time the system is armed in the stay mode
the preselected stay zones will be bypassed automatically. This also depends on which stay prifle is
active (5.3.1).
NOTE:
Instant zones, such as panic zones, cannot be selected.
12.1 To Program Stay Zones
[3] + [ZONE NUMBER] + [*] + [#]
1.
Hold down the
[3]
key until the keypad buzzer sounds. The AWAY indicator will flash to show that
the panel is in the Stay Zone programming mode.
2.
Press the
[NUMBER]
corresponding to the zone you wish to be a STAY zone.
3.
The relevant zone indicator will come on. (Buzz zones will be shown by flashing indicators. See
Section 13. A Buzz zone cannot be selected as a Stay zone; the Buzz status must be cleared
first.)
4.
Repeat step 2 until all stay zones are selected.
5.
Press the
[#]
key to exit the Stay zone programming mode.
Summary of Contents for IDS 805
