KF100, Pebble, Ergo | © 2020 Inim Electronics S.r.l.
7
3.1 Enrolling a wireless device
3. Installation of remote-control keys Air2
The Air2 requires enrolling only.
If it becomes necessary to replace the rubber button cover or battery, work through the following steps:
1. Remove the enclosure screw on the back of the remote-control key and open the device.
2. Remove the rubber button cover.
3. Replace the cover/battery as required.
4. Close the device and replace the enclosure screw.
5. Enroll the remote-control key.
3.1 Enrolling a wireless device
The enrolling procedure allows you to associate a wireless device INIM with the transceiver Air2-BS200
which acts in conjunction with the intrusion control panel.
This procedure varies depending on the control panel in use and the programming software or application:
1. Access the control panel programming.
2. Select the device to be enrolled in accordance with its type:
an input terminal, for a detector (motion detector, magnetic contact, etc.)
an output terminal, for an output device connected to a terminal of a magnetic contact Air2-
MC300
a keypad
a sounder/flasher
a key, for a remote control device, selecting as the associated reader the one simulated by the
transceiver
3. Set the device as “Wireless”.
4. Start the learning phase from the control panel.
5. Press simultaneously buttons
F3
and
F4
on the remote-control key.
3.2 Battery replacement
When changing the battery, it is advisable to press simultaneously buttons
F3
and
F4
in order to be sure that
the device is synchronized with the wireless transceiver.
