Installation and Programming manual
General information
7
Chapter 2
General information
2.1
In-box documentation
The power supply station comes with a combined "Installation and Programming Manual" (this document).
If you require extra copies, please contact INIM electronics offices and quote the order number shown in
Appendix B Order codes
.
2.2
Document details
• Title: SmartLevel installation and programming manual
• Edition, Issue: 1.21
• Month and year of issue: February 2012
• Manual code: DCMIINIESPS24
• Addressees: the installer company, technical assistance technicians
2.3
Software information
• SmartLevel Firmware Version: 1.0.x
2.4
Operator qualifications and Access levels
The SmartLevel power supply station has been especially designed to comply with EN-54-4 (including the
provisions of EN 54-4:1997/A2:2006). User Access
Level 1:
Building occupants
Using the graphic screens, building occupants can view the status of the outputs and the output
voltage. Furthermore, they can view the Events Log, silence the power-supply buzzer, test the
LEDs and reset the power supply station.
Level 3:
Authorized technicians appointed by the Installer company.
These technicians can, by means of the necessary tools, remove the frontplate of the power
supply station. They can insert the respective jumpers in order to access and carry out
programming and maintenance. Processing is inhibited during programming sessions,
therefore, the device will be unable to generate any signals whatsoever.
Level 4:
Technicians employed by the Manufacturer (INIM Electronics s.r.l.).
These technicians can, by means of special tools, repair or replace the device components.
Note:
This manual is for Authorized technicians (Level 3), however, it also describes some information
regarding the end user (level 1).
2.5
Intellectual property rights
The information contained in this document is private property. All rights reserved.
No part of this document may be copied, whether totally or partially, unless expressly authorized in writing
by INIM Electronics, in particular the parts regarding the device specified in paragraph
2.13 Device labels
2.6
Disclaimer
INIM Electronics s.r.l. shall not be responsible for damage arising from improper application or use.
Only qualified personnel (refer to Terminology) should touch this device. Installation must be carried out
strictly in accordance with the instructions described herein, and in compliance with the local fire code in
force.
