InisBofin Insert Roomheater
and when igniting the stove. If
excess fuming to the room results
at any time when the door is
opened, it should be closed
immediately and expert help
sought.
The stove has been designed for
ease of use by the operation of
just one air control slider. The
damper slider governs all the air
flows throughout the stove for
optimum efficiency and
performance. This adjustment
slider is found on the top of the
stove to the left side of the
facade. To operate the damper
slider, use the hand tool to move
the slider to the left side to
close the damper and to the right
side to open the damper. No
adjustment of the damper assembly
is necessary. To help keep the
stove glass clean, load the fuel
toward the back of the stove when
lighting and use kindling which
lights quickly and fire the stove
at a high rate for 25-30 minutes
after lighting. To avoid
blackening of the glass avoid
prolonged periods at a very low
setting.
Paint Curing
Please adhere to the curing
procedure described below as over-
firing the stove before the paint
has cured will lead to fading of
the paint and this is not covered
by your warranty.
When the stove is used for the
first number of times the process
of curing the paint will occur. To
do this a small fire using only
kindling wood logs should be
started for approximately 30
minutes, allow the stove to cool
slightly then repeat the small
fire using only kindling wood logs
for another 20 minutes. The final
action to cure the paint is
to put on a normal sized fire
before the stove has cooled down,
at full output for at least one
hour. The stove paint will emit
fumes with are non-toxic but a
window should be opened to avoid
fume build up during the curing
process.
Before you operate the stove,
consult with the installer that all
the relevant work has been carried
out correctly and that they have
ignited a small fire in the stove
and it is operating correctly.
Check that all relevant local,
national and European Standards
have been adhered to when
installing the stove.
Attention: The insert is designed for intermittent
Operation, i.e. normally a new load of fuel is
loaded after the previous one has burned
completely.
General Points
1. Never use unsuitable and non-
recommended fuels, including
liquid fuels in the stove and
don’t use the stove as an
incinerator
2. When in operation, the stove
will be hot and care should
be taken to avoid injury.