9
Wireless headphone Channel selection
•
Press the SETUP or MENU button to select FM FREQ adjustment
and press UP/DOWN or – button to select an FM
Frequency you want.
Monitor Aspect ratio
•
Press the SETUP or MENU button to select D.MODE adjustment and
press UP/DOWN or – button to select a Display Mode you
want.
Monitor Dimmer
•
Press the DIMMER button to reduce the brightness of the monitor by
half; press it again to resume the brightness.
Dome Lamps
•
Slide the Slide Switch (OFF/AUTO/ON) on the main unit to “ON”
position to turn lamps on.
•
Slide the Slide Switch (OFF/AUTO/ON) on the main unit to “OFF”
position to turn lamps off.
Automatic operation
•
The Dome lamps can be controlled by the car doors. Slide the Slide
Switch (OFF/AUTO/ON) on the main unit to “AUTO” position; when a
door is opened, the two lamps will light; when the door is closed, the
two lamps will go out.
Note: This feature will need to be installed before it will work, please
check with your installation technician.
Wireless Headphones
•
A built in FM signal transmitter transmits the wireless headphone
signal. The signals are transmitted over 7 different and selectable FM
frequencies. The wireless headphones receive these frequencies for
the listener.
•
The FM signal transmitter will transmit over 7 FM frequencies:
87.7MHz, 87.9MHz, 88.1MHz, 88.3 MHz, 88.5MHz, 88.7 MHz, and
88.9MHz. It is possible to receive these signals over any FM radio
tuned to those frequencies. In some cases the vehicles own radio may
pick them up.
o
To change the monitors FM signal transmission frequency,
press the FM TX button on the remote control, and then keep
pressing the FM TX button to shift between the 7 reset
frequencies.
o
To receive the FM transmission on a radio, tune the radio to
the specific frequency selected above. You must be in front of
the monitors screen to receive these signals.
