33
initio
®
3
In the INSTALL DRIVER window, select
HAVE DISK...
.
4
In the INSTALL FROM DISK window that is displayed, enter the Initio Driver path
name:
Insert
INI-9XXXU/9XXXUW DRIVER DISK 1
into drive A:
Type:
A:\WINNT
, select
OK
5
Select
Initio INI-9XXXU/UW PCI SCSI Host Adapter
, select
OK
to install the
INI910U.SYS driver onto your hard disk drive.
6
In the WINDOWS NT SETUP window that is displayed, enter the Initio Driver path
name to continue:
Type:
A:\WINNT
, select
CONTINUE
7
This completes updating the Host Adapter Driver. Follow the on-screen directions to
restart you computer and activate the new driver
8
It is highly recommended that you verify Initios Windows NT device driver has been
properly installed by selecting
MY COMPUTER
from the desktop. Then select
CONTROL PANEL
:
Select
SCSI ADAPTERS
from within the CONTROL PANEL group,
Select
Initio INI-9XXXU/UW PCI SCSI Host Adapter
from within the SCSI
CONTROLLER listing. If This device is working properly is displayed on your
screen, the driver has been correctly installed.
Installing a new Windows NT system and Initio driver
without floppy disks
For computer systems installing or upgrading to Windows NT from a floppyless setup
such as a share on your network, these instructions will guide you through the INI-
9XXXU/9XXXUW host adapter driver installation. The Windows NT drivers are located on
the
INI-9XXXU/9XXXUW DRIVER DISK 1
. It is important that the hardware has been
installed successfully before proceeding further.
1
Execute a floppyless setup as described by the
Windows NT System Administrators
Guide
Microsoft Windows NT Driver Installation
Summary of Contents for I/O HIGHWAY
