40
initio
®
3
Using an appropriate text editor modify the CONFIG.SYS on the OS/2 Diskette 1 for
INI-9XXX to include the new Initio driver.
Enter:
BASEDEV=INI910U.ADD
and save the file.
4
Insert the
Installation Diskette
into drive A: and turn on your computer. This will
begin the OS/2 installation and establish an OS/2 bootable hard drive.
5
When prompted, insert the OS/2 Diskette 1 for INI-9XXX. Follow the on-screen
instructions to continue.
6
You have completed the Initio device driver installation for OS/2. Follow the on-screen
instructions and OS/2 manual for a complete description of OS/2 installation.
Adding the Initio driver to an existing OS/2 system
For computer systems using other SCSI host adapters or an IDE device to provide the
system boot routines, these instructions will guide you through INI-9XXX host adapter
driver installation. The OS/2 driver will be found on the
INI-9XXXU/9XXXUW DVR DISK 1
.
It is important that the SCSI bus hardware and OS/2 are installed correctly before proceed-
ing further.
1
Once an OS/2 session is established, insert the
INI-9XXXU/9XXXUW DRIVER DISK 1
into your floppy drive.
2
By using your installed mouse, or by using the appropriate key strokes, select
DEVICE DRIVER INSTALL
from the SYSTEM SETUP group.
3
Select
CHANGE
source directory to read as the root directory.
4
Select
OS2
and select
SET.
5
Select
DESTINATION DIRECTORY
.
6
Select
CHANGE
destination directory to any existing OS/2 directory or accept the
default.
7
Select
SET.
8
From the DEVICE DRIVER INSTALLATION GROUP select
INSTALL
.
9
Select
INITIO INI-9XXX Device Driver for OS/2
select
OK
.
10
Select
EXIT
to install the OS/2 device driver. Exit and reboot the system to activate
the device driver.
IBM OS/2 Driver Installation
Summary of Contents for I/O HIGHWAY
