Pinch and pull back crank case line from intake tube.
Remove complete stock turbo coupler and clamps
shown above.
Pull out the complete air box assembly.
A) With pliers, pinch the clamp holding in intake tube
at the turbo.
B) With T30 torx bit, loosen and remove the screw
holding in intake tube neer fire-wall on engine.
Pull out ram air elbow from air box.
With pliers, carefully pinch clamp and pull intake
tube away from air box.
Stock box shown in this picture
Pinch the harness on smog pump and pull away from
air box. (if equipped with smog pump)
Disconnect MAF sensor harness and set aside.
With T30 torx bit, loosen the screw holding in air box.
Remove engine cover.
A) Remove intake tube out of vehicle.
B) Pinch remaining clamp on turbo and remove.
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Figure 14
Page 2 of Part# SP3071
A
B
A
B
