Re--connect MAF sensor harness.
Remove the 2 screws holding in Stock ram air unit.
Remove the ram air unit. Save the screws for new
Injen power-ram install.
Tighten the remaining clamp on step hose using 8mm
nut driver.
Secure the bracket on intake tube using provided M6
washer and nut. Tighten the nut using 10mm socket
and ratchet.
Install the MAF sensor to the intake tube.
Install the intake tube into vehicle and position to
turbo and bracket to vibra mount.
A) With T20 security bit loosen the 2 screws holding.
B) Remove MAF sensor.
Tighten the clamp on the turbo only using 8mm nut
driver.
A) Secure the vibra mount to stock thredded
mounting position of air box.
B) With clamps provided, install the step hose to
turbo.
Secure the MAF sensor to tube using provided M4
screws and tighten using 2.5mm allen key.
A) Connect smog pump harness (if equipped) to new
intake tube. If not equipped, use provided plug.
B) Connect crank case line to intake tube.
Note: make sure that both harness’ are complete-
ly snapped in place
.
install engine cover.
Figure 15
Figure 16
Figure 17
Figure 18
Figure 19
Figure 20
Figure 24
Figure 25
Figure 26
Figure 23
Figure 22
Figure 21
Page 3 of Part# SP3071
A
B
A
B
A
B
