Inkbird IHT-2PB, Operation Instructions Manual

● 

Please do not allow the probes or the probe cables to 

touch the fire, or it may result in burning and fusing.

● 

Please insert the probe deep enough into the meat if 

the display reading value is too high or increases too 

quickly.To detect the temperature of the meat, probes 

shouldbe inserted into the thickest part of the meat. 

Avoid bones and fat.

● 

Please wear gloves when you clean or use the probes. 

Do not touch the probes or cables immediately after use, 

or it may result in scalding or stab wounds.

● 

Please keep the probes away from children to avoid 

possible harm.

● 

Please clean and air-dry the probes after use.

● 

Please do not immerse the thermometer in the water, 

though it can be rinsed with water.

● 

Please do not clean the jack plug of each probe with 

water, or it may cause bad contact.

● 

Please do not use the stainless steel probes in 

09

Product Warranty

10

FCC Requirement

microwave ovens.

● 

Please do not use the product beyond the temperature 

range from -50℃ to 300℃ (-58℉ to 572℉), or it may cause 

damages.

● 

Children aged 12 or under 12 should use it with parental 

guidance.

This item carries a 2-year warranty against defects in 

either components or workmanship. During this period, 

products that prove to be defective will, at the discretion 

of INKBIRD, be either repaired or replaced without charge.

changes or modifications not expressly approved by the 

party responsible for compliance could void the user’s 

authority to operate the equipment. 

This device complies with Part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, 

including interference that may cause undesired 

operation.
Note: This equipment has been tested and found to 

comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are 

designed to provide reasonable protection against 

harmful interference in a residential installation. This 

equipment generates, uses, and can radiate radio 

frequency energy, and if not installed and used in 

accordance with the instructions, may cause harmful 

interference to radio communications. However, there is 

no guarantee that interference will not occur in a 

particular installation. If this equipment does cause 

harmful interference to radio or television reception, 

which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and 

receiver.
– Connect the equipment into an outlet on a circuit 

different from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV 

technician for help.
This equipment complies with FCC radiation exposure 

limits set forth for an uncontrolled environment. This 

equipment should be installed and operated with a 

minimum distance of 20cm between the radiator & your 

body. This transmitter must not be co-located or 

operating in conjunction with any other antenna or 

transmitter. 

- 25 -