7-5 A
SSEMBLE
P
RINT
H
EADS WITH
I
NK
T
UBES
Note
: The following procedures take water-based print heads as example; the installation procedures of installing
print heads on UV system are exactly the same, except that the ink tubes and connectors should be for UV ink.
1
Cut the long ink tube (
Φ
4
) into 24 sections of short tubes whose length is about 3.8cm and 12 sections
of long tubes whose length is about 10cm.
2
Plug one short tube onto each ink inlet of print head. Make sure the tube gets to the bottome of the
inlet.
3
Then connect every two short tubes at the same side with a Y-shape connector. Make sure the tubes
get to the bottom of the connector’s two outlets. Please see the image below:
4
Install a long section of tube to the inlet of each Y-shape connector.
5
Now please differentiate the front and end sides of the print head. Check the two holes at the ends of
nozzle line; one is a long one, the other a round one. The side with the long hole is the front side of the
print head.
6
Install a luer connector and a luer lock on long tube at the end side of the print head.
INKCUPS NOW SERIES INKJET PRINTERS
XJET
All rights reserved by Inkcups Now Corporation
Rev: SC71112
Page 64 of 100
