Rev 2
Page 2 of 2
Document No. 3000/QF/620
Cutting Head:
The cutter head is designed with a hole that a simple (smokers, not craft) pipe cleaner can be inserted into
for removing accumulated glass chips and cutting debris. This keeps the wheel rotating freely. Keep corrosive materials
like soldering flux away from your ScoreOne™.
Lubrication
: You periodically need to lubricate the axle the carbide wheel rotates on. Using a
cutting fluid like Inland RinsesOff™ or plain mineral oil, take a short 3/4" length of pipe cleaner, dip
it in lubricant and then insert it into the hole in the head and bend it back out of your line of site. This
acts as a wick to keep the wheel oiled.
Cutter Head Replacement:
The cutter head supplied with your machine will eventually wear and
need replacement. When simple scores don’t break easily or the head appears to "skip" when making a score it is probably
time to replace the head.
1. Partially remove the Phillips screw holding the hand knob (6) in place. Give the knob a light tap to loosen, then
remove the screw and pull the knob off.
2. Pull the drive roller (1) forward out of the body about 2 inches.
3. Insert a small nail or wire into the hole in the cutter head and force downward to remove.
4. Replace with the new cutter head.
5. Push the drive wheel back in place.
6. Refasten the hand wheel (6).
Rubber Drive Treads:
Clean treads with a little acetone (non-oily nail polish remover). Be careful not to get it on the
body, it will stain the surface. You can also remove the tread and turn it inside out for a second life span. Replace the tread
by lifting an edge with your fingernail and peel it off the hub (1). The replacement just stretches back in place.
Replacement Parts
: Inland no. 50051
Accessories
ScoreOne™ Circle / Strip Accessory
Use your ScoreOne to make circles, from 1 ½" to 13" in diameter, and
strips, as narrow as 3/8" and up to 3" wide, without interfering with its normal operation. This accessory is
included with the ScoreOne Plus and available as an add-on for the ScoreOne. Inland no. 50056
™
:
Our water soluble cutting fluid will help to properly lubricate and maintain the carbide cutting
wheel for longer head life and better breaking scores. Inland no. 50057
Service
If you have any questions or comments regarding the use of this or any Inland product please call Inland Customer
Service at 1-800-521-8428 9 AM to 5 PM EST, email us at
, or write us at:
Inland Craft Products, Co.
32052 Edward Dr.
Madison Heights, MI 48071
