3
© 1998 - INLINE, INC.
IN3606 / IN3656 / IN3666 OPERATION MANUAL - REV. 1.1 11/27/99
Programming Options
♦
RGB Delay
Only H and V inputs of a particular input is switched immediately. This is to allow for resizing and
syncing of monitors before the RGB picture elements are sent. The RGB inputs are switched a time
period afterwards. This time period is programmable in half second increments from one half second to
7.5 seconds. (See Programming Procedures)
♦
Vertical Interval Switching
Switching between inputs occurs during the vertical interval sync pulse therefore eliminating screen jitter
while switching.
Programming Procedures
There are two ways of programming the IN3600 Series. One is by RS232 communications, the other by
power up settings. Power up settings are accomplished by holding a particular input button while
simultaneously powering up the unit.
POWER ON SETTINGS
To Reset Unit to Factory Defaults - Hold down INPUT 1 button during power-up.
The default settings are:
Front Panel enabled
Vertical Interval Switching off
Master Switcher
1200 baud
“[ ]” command codes
Manual Switching (Scan off)
Blank sends nothing to output
To Set Miscellaneous Functions - Hold down INPUT2 button during power-up:
A.
BLANK LED goes solid
B.
Letting go of INPUT2, BLANK LED flashes
C.
Switches INPUT1 through INPUT4 are toggling options:
INPUT1 on = Vertical Switching on off = Vertical Switching off
INPUT2 on = Front Panel disabled off = Front Panel enabled
INPUT3 on = Auto Switching on
off = Auto Switching off
INPUT4 on = Sync on Blank
off = Nothing on Blank
D.
Depressing BLANK button saves this part of configuration and Blank LED flashes slower
E.
Switches INPUT1 and INPUT2 are alternate action selections:
INPUT1 on = Master mode
INPUT2 on = Slave mode
F.
Depressing BLANK button saves this part of configuration and Blank LED turns off.
