4
MSV0502 OPERATION MANUAL - v1.0 4/26/02
2002 - INLINE, INC.
Installation
Below are instructions for installing the MSV0502 Matrix Switcher. An application diagram showing
typical connections is on page 4.
Note:
Prior to initiating the installation procedure, ensure that there is no
power supply cord connected to the unit
1. Place/install
the
MSV0502 at the desired location. Seat the unit on a flat surface or securely
install it in a standard 19" equipment rack using the MTR102 rack ears (provided). The
MSV0502 is exactly 1U high without the feet. If other equipment will be located in the space
directly below the matrix switcher, you must remove the rubber feet on the bottom of the unit
before mounting it in the equipment rack.
2. Connect the output display devices (monitors, data projectors, etc.) to the matrix switcher VGA
connector outputs. The MSV0502 features two 15-Pin HD video outputs for easy connections to
display devices. You can connect display devices with a 15-Pin HD input directly to the
MSV0502 15-Pin HD output ports using standard VGA cables. INLINE’s IN8000 Series
flexible VGA cables offer exceptional performance and are available in a variety of lengths.
3. Connect
the
MSV0502 analog stereo audio output (5-pin captive screw terminal) to the audio
system’s line level input (mixer, amplifier, powered speakers, etc.). The output can be set for
balanced or unbalanced output signal as required by wiring the output appropriately (see wiring
diagram below). The analog audio output connector will accept stranded or solid cables from 20
- 26 AWG.
For Unbalanced Stereo Audio Output:
For Balanced Stereo Audio Output:
4. Connect the input video sources to the matrix switcher’s VGA connector inputs.
5. Connect the audio sources to the audio inputs. All five inputs accept balanced or unbalanced
stereo audio signals. Connect the audio signals to the 5-pin captive screw connectors according
to the wiring diagram on page 9.
6. If desired, connect a control system, computer, or other serial command source to the RS-232
remote connector. Cable the control system or computer serial port to the serial port based on
the type of connection described on page 9.
7. Connect power to the Matrix switcher, display devices, and serial and audio equipment as
applicable. To connect power to the switcher, attach the power cord to the connector on the rear
of the set. A standard IEC power cord comes with the unit. Plug it into a
100 – 40 VAC, 50Hz or 60Hz power source.
