IDE Driver installation
53
10.3 Installing the drivers for SCO UNIX 5.0.0
!"
install :
# mkdir /alihdd
# doscp a:/sco-unix/alihdd.tar /alihdd
# cd /alihdd
# tar xf - < alihdd.tar
# ./istl.alihdd
when you see :
A new kernel must be built and rebooted.
Would you like to relink at this time?"
Press y
# reboot
!"
uni
# cd /alihdd
# ./rm.alihdd
when you see :
A new kernel must be built and rebooted.
Would you like to relink at this time?"
Press y
# reboot
IDE Driver installation
54
10.4 installing drivers for Window 95/98?
One of the two methods listed below can be used to install driver:
!"
Use INSTALL.BAT under Windows 95 environment.
OR
!"
Use the following sequence step by step:
1. Popup 'Control Panel' and open 'Add New Hardware'. Choice 'Next'.
2. Switch to 'No' - don't let Windows to search for your new hardware, and click 'Next'.
3. Select 'Hard disk controller' and click 'Next'.
4. Click the button 'Have Disk' ( or press Alt+H ).
5. Make sure the install disk is in drive A(or drive B), and then click 'OK'. A 'Select
Device' dialog box will be popup.
6. Select the device that you wish to install and click 'Next'.
7. After this install procedure is complete, you may need to restart the computer.
Attention :
1. When the Win95 install the software for primary and secondary channel for IDE
driver, please DO NOT RESTART COMPUTER after Win95 just finish primary
channel. Let Win95 continue to install software for secondary channel. After
secondary channel is finished, the RESTART COMPUTER to let new installed IDE
driver to take effect.
2. DOS CD-ROM and IDE drivers will conflict with ALi bus master driver in Win95.
Please remove "mscdex" command line from autoexec.bat and remove the
specification "device=Your DOS CD-ROM and/or IDE driver" from config.sys.
3. Sometimes, the ALi IDE controller has already been installed with the standard driver
provided by Microsoft. In order to use ALi IDE controller with the driver we provided,
it is necessary to remove the standard driver from "Control Panel/System/Device
Manager".
4. This version support Ultra-33 feature.
