18
2a) Wall Mounting Orientation
There are nine screw holes available for mounting
the bracket to a wall. It is recommended that
a minimum of 2 screws are used to ensure the
docking station is mounted securely.
There are four keyhole shaped slots in the
mounting bracket that mate with feet on the
rear of the docking station. To attach the
bracket, the larger end of the keyhole will pass
over the feet. The dock is then slid down to lock
the feet into the narrow section of the keyhole.
WARNING
DO NOT pull with force on the cables from the rear
of the IsatDock2 MARINE. Please install strain relief
clamping for the antenna cables where required.
Correct installation of the antenna system is a vital
part of the IsatDock2 MARINE system, to ensure
reliable functionality, and drop-free calls.
WARNING
Changes or modifications not expressly
approved by BEAM Communications could void
the product warranty.
WARNING
To satisfy FCC RF exposure requirements for mobile
transmitting devices, a separation distance of
55cm or more should be maintained between the
antenna of this device and persons during device
operation. To ensure compliance, operations at
closer than this distance is not recommended.
WARNING:
Do not place the antenna anywhere there is a
source of heat or fumes such as the ship’s exhaust.
Once the dock has been locked onto the
mounting bracket on the wall, the security bolt
is then slid into place locking the dock to the
wall.
a
b
c
Slide the dock down
Fit the docks feet in the large holes of the bracket
Final lock position
Summary of Contents for IsatDock2 MARINE
Page 1: ...IsatDock2 MARINE User Manual Inmarsat Approved ...
Page 2: ...2 ...
