24
User Controls
The user controls are located on the right hand side of the desktop ledge and control the following basic operations of
the Dynamic Desk:
GO
STOP
E
F
G
H
I
PAUSE
E.
GO:
Press to begin moving the belt at 0.3 mph and start a session.
F.
Pause:
Press to pause the walking belt and the session. The GO key will blink during PAUSE mode. The
console displays a 10 minute countdown during Pause mode. Press the GO key to resume session. Press the
STOP key to stop session. The session will end if no keys are pressed during the 10-minute Pause Mode. The
console displays a 3-2-1 countdown when a session is resuming from Pause mode.
G
Stop:
Press once to stop the session and slow the belt to a gradual stop. Press twice to clear session data.
H.
Raise / Lower Desktop Height:
Press to change the desktop height gradually, raising (UP ARROW) or
lowering (DOWN ARROW) the desk height. Desktop height ranges from 36 in. - 48 in. (914.4 mm - 1219.2 mm)
above the walking belt.
I.
Increase / Decrease Speed:
Press to change the belt’s speed gradually, increasing ( “+” button ) or
decreasing (“-” button) the speed by 0.1 mph each time the buttons are pressed.
Summary of Contents for DYNAMIC DESK
