9
Connecting the STB
You require:
•
The home gateway unit
•
Ethernet RJ-45 UTP cable
•
STB unit
1. Plug one end of the Ethernet cable to one of the two ports on the home gateway as
shown in the picture (
LAN 1
or/and
2
).
2.
3. Plug the other end of the Ethernet cable to the Ethernet port on your STB device.
Note: Your STB device may differ from the sample device in this picture. The
picture shows only how to connect a STB device to your home gateway. For
instructions on how to power-on your STB and how to connect it to your TV
set, please refer to the user documentation that came with your STB device.
Note: The ports can be pre-configured for specific service - data (PC) or video
(TV). You will obtain this information from your service provider, then plug
your device to the designated port accordingly.
When the home gateway is turned on and your STB connected, observe the corresponding
LAN
light indicator. The light is on uninterruptedly or occasionally blinks. If you have properly
connected the STB device to your TV set, you can start using the IPTV and video services
immediately.