![background image](http://html1.mh-extra.com/html/inno/if44/if44_installation-instructions-manual_2062284004.webp)
Open Cover A and C. Place them on Bottom B in predetermined length positions.
4
Remove the filler caps on Cover A and C as necessary, depending on your position.
Short position
Medium position
Long position
5
: Remove all the four filler caps from Cover A and C.
: Remove the two filler caps from the shorter Cover.
*1
: Keep all the four filler caps on.
*1: Cover C if installed on the left side on the vehicle
−4−
Groove
Filler cap
Cover A
Cover C
Pinch with your thumb and finger
to remove Filler cap
Groove
This illustrates Short position.
Open Cover B. Align the nut on the frame edge with the hole on Bottom B that is proximate
to the center. Loosely bolt all of four nut portions with the hexagonal concave bolt.
3
Frame
Loose bolting
Cover
B
Hex Wrench
Hexagonal concave bolt
As Body B is not equipped with a damper between Cover B and Bottom B, Cover B goes freely as far back as to the
other side. When opening Cover B, take caution to avoid damage.
Engage Bottom A and C in the grooves on Bottom B as per each position.
For Medium position, ensure the Body (either A or C) on the vehicle front side is longer than the other on the rear.
Note
Note
Cover B
Body B
Bottom B
Bottom C
Cover A
Body A
Damper between
Cover A and Bottom A
Bottom B