![background image](http://html1.mh-extra.com/html/inno/if44/if44_installation-instructions-manual_2062284008.webp)
Open the lever, and rotate the adjuster knob to
the direction indicated by the arrow (counter
clockwise) by about 5 turns to make the hook
space narrower. Confirm that the base bar
center matches the center between hooks,
close the lever to securely tighten. If the lever is
loose, rotate the adjuster knob more. If the lever
is too tight, reverse the direction of the adjuster
knob and securely tighten.
3
Cut the mold L to the length of the open slit.
Press down the cut mold L into the open slit to
fill it.
4
−8−
Hook
Convex shape
Lever
Cut
Slit
Slit
Press down
Mold L
Cut
Forcefully press down the cut mold L so that its entire upper
surface is evenly flat.
When the square bar is placed, keep the tips of the hooks as
close as illustrated.
*Adjuster knob has a convex shape to indicate how many
turns are made.
*Depending on the shape of the base bar, make more or less
turns to tighten the hooks.
If the height of the 2 hooks differs, the hook center will not
match the base bar center.
Check that hooks are symmetrically positioned.
The hooks may loosen over time if they are not symmetrically
positioned.
Readjust the adjuster knob to tighten.
Precautions
Note
Note
Note