47
INNOCIGS EVIC VTC DUAL BODY – OPERATING & CHANGING THE MODES
2. Installing new atomizer coils
If an atomizer coil is replaced with one which has a greater resistance than the previous one, it is
important to reset the “Base Resistance” of the atomizer. This is the resistance of the coil at room
temperature. Initiate a reset by pressing the fire button of the eVic VTC Dual while the clearomizer is
not attached. After connecting the clearomizer with new head and the eVic VTC Dual, “New Coil Right
(up), Same Coil Left (down)” will appear on the display. Confirm that a new coil has been installed by
pressing the “up” button.
If you see this message in other instances - especially when you reinstall the same coil which is still
warm from recent use - press the down button, so that the “base resistance” is not reset.
Always remember to adjust the operating mode of the coil used to ensure proper temperature
control.
