© INNOLUX Corporaon │ X
_____________________________________________________________
Caution
_____________________________________________________________
4.1.4 Charging the Battery Pack for the Flat Panel
Detector
Use the battery charger recommended by INNOLUX Corporation.
on operations, refer to the instruction manual for the battery charger.
4.1.5 Installing/Removing the Battery Pack for the Flat
Panel Detector
Follow the procedure below to install/remove the bat
detector. When installing/removing the battery pack, place the flat panel
detector on a flat place.
Do not remove the battery pack until a processed image appears in the
window of the image processing unit after the exposure.
Do not place the connector
on a hard surface such as
the edge of a bed.
© INNOLUX Corporaon │ X-Ray Products
_____________________________________________________________
_____________________________________________________________
Charging the Battery Pack for the Flat Panel
Use the battery charger recommended by INNOLUX Corporation.
to the instruction manual for the battery charger.
Installing/Removing the Battery Pack for the Flat
Follow the procedure below to install/remove the battery pack for the flat panel
When installing/removing the battery pack, place the flat panel
Do not remove the battery pack until a processed image appears in the
window of the image processing unit after the exposure.
Do not place the connector
on a hard surface such as
the edge of a bed.
Make sure that the connector
does not protrude from the
edge of a bed.
Do not raise the flat panel
sensor by
connector
35
_____________________________________________________________
_____________________________________________________________
Charging the Battery Pack for the Flat Panel
Use the battery charger recommended by INNOLUX Corporation. For details
to the instruction manual for the battery charger.
Installing/Removing the Battery Pack for the Flat
tery pack for the flat panel
When installing/removing the battery pack, place the flat panel
Do not remove the battery pack until a processed image appears in the
Do not raise the flat panel
sensor by holding only the
connector.