Using Diagnostic Tool Memory
VIEWING DATA IN MEMORY
90 3100j
When you retrieve DTCs from a vehicle, the data is saved to the
diagnostic tool’s memory.
Each time you retrieve DTCs, existing data in the diagnostic
tool’s memory is overwritten with the new data.
VIEWING DATA IN MEMORY
When you turn the diagnostic tool on while NOT connected to a vehicle,
and data is currently saved in the diagnostic tool’s memory, the
diagnostic tool enters Memory mode. You can view DTCs and Live Data
stored in the diagnostic tool’s memory.
1.
With the diagnostic tool NOT connected
to a vehicle. press and release the
POWER/LINK
button to turn the
diagnostic tool on.
If the diagnostic tool’s batteries are
low, a warning message displays.
Replace the batteries before con-
tinuing.
2.
If more than one vehicle is stored in the
diagnostic tool’s memory, the Vehicle
Selection menu displays. Use the
UP
and
DOWN
buttons, as
necessary, to highlight the desired
vehicle, then press the
ENTER
button.
If there are no vehicles
currently stored in the
diagnostic tool, an advisory
message displays. Press the
M
button to return to the Main
Menu.
The Memory System Menu displays.
3.
Use the
UP
and
DOWN
buttons, as necessary, to highlight the
DTCs you wish to view, then press the
ENTER
button.
The diagnostic tool displays the
"priority" DTC.
If there are no DTCs currently
stored in the diagnostic tool’s
memory, an advisory message
shows on the display.
Summary of Contents for 3100j
