Innova S.r.l.
Pag. 23
N420227A_ManualeHRC_ Rev06.EN.docx
EXAMPLE :
The figure beside the remote controller responded
automatic cycle and the speed 'maximum.
Status request from remote system
AUTOMATIC
1
If you press the Auto button, the unit enters the
mode '
Automatic.
In this mode, the blower unit "Master" detects the
environmental parameters (temperature, humidity
and brightness) and carries out the procedures and
calculations indicated below to ensure the best
environmental comfort.
Every single slave instead regulates the ventilation
as a function of its light and humidity sensors.
Operation Auto mode
EXTRA
CYCLE
RECOVERY
OPERATION
AND
REGENERATIVE
MODULAT
The master drive mode has the purpose of
controlling the entry and extraction time to optimize
the system's regenerative recovery cycle.
At the first activation of the "Auto" mode, after 10
minutes and subsequently every 12 hours, the
"Master" ventilation unit performs the procedure
"Extra-cycle" to detect the temperature difference
between the environment and the outside in order
to determine the duration of the "Auto cycle" most
suitable which will also be adopted by any
ventilation "Slave" units present in the plant.
The procedure "Extra-cycle" lasts five minutes,
during which communication with the transmitter is
inhibited; at this stage, any commands given with
the remote control will have as abutment three
flashes of the LEDs.
The duration of the recovery cycle is determined in
Auto outcome of the "Extra-cycle" procedure and it
can vary between 30 and 200 seconds, which will be
shared equally between the extraction phase and
the placing.
Operation Extraciclo recovery and regenerative modulating
