Innova S.r.l.
Pag. 31
N420227A_ManualeHRC_ Rev06.EN.docx
8.3 CVR - aesthetic Cover
The unit involves the use of a series of aesthetic
covere available when ordering.
The replacement of the cover of the product series
takes place through a few simple operations:
-Remove the motor support cover and carried out
as indicated for the cleaning and removal of the
filter.
-Svitare the four screws holding the rear cover of
the standard plastic finish.
-Place the cover aesthetic choice and replace the
four screws of the new cover.
CVR - aesthetic Cover
8.4 KUA - Corner installation output Kit
The kit provides for the possibility 'to install the
product
with the discharge does not direct on the wall, but
with the direction of the angular flow.
For example, if you have the shoulders between the
window and the outer wall, and 'you can mask the
grid using the kit and exiting at an angle close to
the window frame.
KUA - angled output Kit
8.5 KDP - the preparation kit
The kit includes the possibility 'prepare for the
installation of the product under construction.
The kit consists of a plastic tube
of slightly greater diameter of the pipe
telescopic standard supplied with the appliance.
And an internal cap made of expanded polystyrene
to prevent the leakage of air and have the insulation
heat up to the moment of installation of the
product.
KDP - Kit specifying unit
