·
Perform grounding
Does not connect the earth wire to a gas pipe, water pipe, lightning rod or telephone earth wire.
Defective grounding could cause an electric shock.
·
Do not install the unit in a place where an inflammable gas leaks.
If gas leaks and accumulates in the area surrounding the unit, it could cause an explosion.
·
Fasten a flare nut with a torque wrench as specified in this manual.
When fastened too tight, a flare nut may break after a long period and cause a leakage of refrigerant.
·
Install an earth leakage breaker depending on the installation place(where it is humid).
If an earth leakage breaker is not installed, it could cause an electric shock.
·
Perform the drainage/piping work securely according to the installation manual.
·
If there is a defect in the drainage/piping work, water could drop from the unit and household goods
could be wet and damaged.
CAUTION
2
·
Do not let air enter the refrigeration system or discharge refrigerant when moving the air conditioner.
·
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
·
Children should be supervised to ensure that they do not play with the appliance.
·
If the appliance is fixed wiring, the appliance must be fitted with means for disconnection from the
supply mains having a contact separation in all poles that provide full disconnection under over
voltage category III conditions, and these means must be incorporated in the fixed wiring in
accordance with the wiring rules.
·
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
·
The appliance shall be installed in accordance with national wiring regulations.
·
Servicing shall only be performed as recommended by the equipment manufacturer.
·
The method of connection of the appliance to the electrical supply and interconnection of separate
components is detailed in below part. The wiring diagram with a clear indication of the connections
and wiring to external control devices and supply cord is detailed in below part.
·
In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not
be supplied through an external switching device, such as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
·
It is necessary to allow disconnection of the appliance from the supply after installation. The
disconnection may be achieved by incorporating a switch in the fixed wiring in accordance with the
wiring rules. During service and when replacing parts, be sure to disconnect the appliance from its
power source. If the disconnection is not foreseen, a disconnection with a locking system in the
isolated position shall be provided.
·
The information of dimensions of the space necessary for correct installation of the appliance
including the minimum permissible distances to adjacent structures is detailed in below part.
·
This appliance is intended to be used by expert or trained users in shops, in light industry and on
farms, or for commercial use by lay persons.
·
Instructions on addition charging of refrigerants are detailed in below part.
Safety instructions
Safety precautions
Summary of Contents for 18K
Page 17: ......