B
C
1)
Drop the ballasts in the step
holes.
2)
Insert the rear posts into the
lateral supports.
3)
Insert the handrails over the
two front posts. Mark on the
rear posts with a pencil where
to cut posts so that they fit in
the handrails.
4)
Cut the posts.
D
1)
Secure the lateral supports and the handrails to
the posts using the screws provided.
2)
Secure the lateral supports to the deck using the
screws provided.
x8
Sand
30 lbs
1)
Fill the ballast
with sand. The
approximate weight
should be 15 lbs
per ballast.
Align holes
2)
Screw the lid in place
and align the cover ribs
with the holes in the
ballast base.
3)
Fasten the cover to the
ballast base with the four
screws provided.
x8
B
4)
Slowly submerge the
step into the pool. Make
sure you do not damage
the pool liner in the
process.
5)
Angle the whole step
so that it is entirely under
water. Purge all the air
from under the steps.
6)
Slide the lateral
supports to the height of
the deck.
REV. 03/06/2020 PN:
PG:2
2257 route 139
Drummondville, Québec
J2A 2G2
1 year on pool step.
1 year on hardware.
MANUFACTURER WARRANTY
WWW.INNOVAPLAS.COM
x24
B
A
ELEGANT WITH DECK
