22
OPERATING THE
SPA CONTROLS
PUMP OPERATION
The spa pump will operate at two different speeds which enable you to control the intensity of the spa jets. To change the pump
speed, simply depress the «Jets» icon on the top side control. The icon has three positions: low speed, high speed and off.
OZONE AND UV WATER CLEANING SYSTEM
If your spa is equipped with an ozone or UV water cleaning system, it will be located in the equipment cavity. The system operates
automatically and only when the spa pump is running on low speed. When it is on, the ozone or UV cylinder will emit a bluish green
light. It is recommended that you check for this light on a regular basis to ensure that the cleaning system is functioning properly.
SPA JETS
All the therapy jets in the spa are individually adjustable. By turning the jets clockwise or counter clockwise, you can control the
intensity of the water flow. Turning the jets clockwise will reduce the water flow until the jets are completely shut off. Turning them
counter clockwise will increase the water flow until the jets are in their wide open position. Please note that you shouldn’t close too
many jets at once or you may damage your spa.
AIR CONTROL VALVES
There are two air control valves located on the top of the spa. Each valve controls air flow to the therapy jets at each end of the
spa. By opening and closing these valves, you can regulate the amount of air that will mix with the water that is entering the spa
through the jets. This will change the intensity of the jet action. When you are not using your spa, it is critical to ensure that these
valves are in their closed position. This prevents cold, ambient air from entering the spa water when the spa is operating in filter or
heating mode and it makes the spa operation more energy efficient.
wATERFALL
LOUNGE
SHELL
AIR
cONTROL
VALVE
cAbINET
dRAIN
SERIAL
#
TOp
-
SIdE
cONTROLS
jET
pILLOw