19
ELECTRONIC AND
ELECTRICAL REPAIR
The following section will describe repair procedures and
trouble shooting hints for the game electronics.
Please read the section “Operational Background” in the
beginning of Maintenance and Trouble Shooting to get a
good understanding of the game’s basic operating pa-
rameters.
WARNING: EXERCISE CAUTION WHENEVER WORK-
ING WITH ELECTRONICS, THEY CAN BE VERY SUS-
CEPTIBLE TO DAMAGE FROM SHORT CIRCUITING,
OR PHYSICAL ABUSE. ALWAYS UNPLUG THE GAME
WHEN WORKING ON HIGH VOLTAGE AREAS OF THE
GAME, SUCH AS THE TRANSFORMER.
USE EXTREME CAUTION WHEN USING VOLTME-
TERS TO DO CIRCUIT CHECKS IF THE GAME POWER
HAS BEEN LEFT ON.
ALWAYS REMOVE THE BATTERY BACK-UP POWER
WHEN WORKING ON THE GAME. THIS IS NECES-
SARY AS SOME CIRCUITS ARE CONSTANTLY UN-
DER POWER FROM THE BATTERY.
WHEN USING A VOLTMETER, BE SURE IS SET TO
THE CORRECT VOLTAGE OR RESISTANCE RANGE
BEFORE USING. THIS CAN PREVENT POSSIBLE
DAMAGE TO THE PC BOARD OR MISDIAGNOSIS.
ALWAYS REMOVE POWER TO THE GAME WHEN
PLUGGING OR UNPLUGGING PC BOARDS.
IT IS NECESSARY TO USE ICE REPLACEMENT
PARTS TO CONTINUE WARRANTY COVERAGE. USE
OF NON-ICE APPROVED PARTS WILL NOT ONLY
VOID YOUR WARRANTY, BUT COULD CAUSE SERI-
OUS HARM TO THE GAME, OR CAUSE SERIOUS
BODILY INJURY.
IF YOU HAVE ANY QUESTIONS REGARDING REPAIR
AFTER READING THIS SECTION, CALL OUR SERVICE
DEPARTMENT BEFORE PROCEEDING AT:
I.C.E. SERVICE DEPARTMENT
716-759-0360
NORMAL BUSINESS HOURS ARE:
MONDAY – FRIDAY, 8:30 AM TO 6:00 PM EST
FUSES
Fuses are the first items that should be checked when the
game is inoperable or works incorrectly.
MAIN TV CABINET FUSE
There is one fuse in the game. The fuse is located on the
side of the Amplifier, located on the right side in the rear
of the TV cabinet. See photo below.
To check or service the fuse, FIRST REMOVE THE
POWER CORD. FAILURE TO DO SO COULD RESULT
IN SERIOUS INJURY OR DEATH.
•
Remove the fuse by simply grasping the fuse with
your fingers and pulling it straight out.
•
REPLACEMENT FUSE: 2222
MARQUEE LIGHTS FUSE
•
Remove the front cover from the Marquee by remov-
ing the 10 screws from the flange around the Mar-
quee cover.
•
Locate the fuse on the printed circuit board and re-
move.
•
Replace the fuse.
•
REPLACEMENT FUSE: 2259
MAINTENANCE & TROUBLESHOOTING
