11
TM
1.
Remove
the
seat
from
the
SmartScoot
by
removing
both
pins
from
the
seat post,
releasing the lever
which loosens the clamp.
2.
Once the optimal
seat
height
is
determined,
insert
one
of
the
adjusting
pins
into
the
hole
by
pressing
on
the
small
knob
and
pushing
it
through
both
holes
of
the
attached
seat
post.
Replace the seat onto the scooter.
3.
Push in the lever which will tighten the clamp. If the
clamp does not tighten, turn the lever on the left
while
holding the screw on the right. This
tightens
the
locking system.
Grab
hold of the lever and pull
it forward until it tightens.
PLEASE NOTE –
Over tightening the screw will
make
it
difficult
for
you
to
tighten
the handle. You
might have to loosen the screw to adjust
tension. The system requires that you use
some force to tighten the latch.
4. Replace the locking pin into the top hole. Press
down the small knob on the pin until the pin is
through both holes in the post.
S
E
AT
S
E
C
U
R
I
T
Y
To ensure seat security while driving or lifting the SmartScoot
TM
the seat must be securely
attached to the unit. There are two steps required to ensuring seat security.
1.
Tightening the clamp by pushing in the lever.
2.
Inserting the security pin into the top hole of the scooter.
