NV200 Family User Manual
<< Back to Contents
Copyright © Innovative Technology Ltd 2016
Doc: NV200 Family Manual
Version: 1.0
Page 42 of 119
Caution!
Only book the credit on the second
Vend pulse!
5.6.5
Busy Control
When the busy line is high the unit is in the process of accepting a note, and a vend
signal is likely to appear shortly afterwards.
5.6.6
Low Power Mode
The Low Power Mode can be used to reduce the power consumption of the NV200
when idle. When the Low Power Mode option is set, the NV200 goes into the Low
Power Mode after about 6 seconds after the NV200 is powered up and remains in
this state until a note is entered. Following a note insertion, the NV200 returns to
Low Power Mode approximately 1 second after a credit is given or note is rejected.
Please see below for timing diagram and further details.
Caution!
In Low Power Mode the front sensor is checked
every second which can lead to a delay in
accepting the note when it is presented!
5.6.7
Credit Hold Function
If this function is enabled the NV200 will take notes as normal but will wait until the
escrow line is toggled low/high before it will give out the pulses per denomination as
set. After the pulses, have been given, the NV200 will wait for another low/high
toggle until the full value of credit pulses are given.
For example, with a setting of 2 pulses per dollar, a five-dollar bill will give 2 pulses
5 times.
Summary of Contents for NV200 Spectral
Page 1: ...Doc GA02031 Version 1 0 ...
