User Manual
–
NV200 Spectral
Copyright © Innovative Technology Ltd 2019
Doc: User Manual NV200 Spectral
Version: 2.1
Page 41 of
95
5.4.1.3
Hardware Setup
The connection example below shows a direct USB connection between the NV200
Spectral and the host machine (PC). This should only be used for
programming/testing. For other connection examples see
5.4.1.4
Switching to Programming Mode (SSP)
Before programming via the Validator Manager, the NV200 Spectral needs to be
switched to its programming mode (SSP interface). Refer to
procedure for doing this.
5.4.1.5
Programming the device
Once you have switched the unit into SSP, open Validator Manager and click detect
devices. This will scan all active com ports for a unit, if the NV200 Spectral fails to
connect ensure the correct drivers are installed and the unit is in SSP.
By selecting the Program tab, you can reprogram the NV200 Spectral. To begin the
upload, click open file, then browse to the file location (usually Downloads) before
clicking OK.