User Manual
–
NV200 Spectral
Copyright © Innovative Technology Ltd 2019
Doc: User Manual NV200 Spectral
Version: 2.1
Page 65 of
95
Flashes
Indicated Status / Error
Recommended Action
Yellow
Cyan
1
1
BNF Lid Open
Close the BNF Lid
2
Pay In Path Jam
Check the upper note path (where notes are
inserted) and clear and jam/debris
3
Pay Out Path Jam
Check the upper note path (where notes are
returned) and clear and jam/debris
2
1
Note Transit Error
Open BNF lid, check that path is clear then
close lid.
2
Note Out Error
Open feeder and NV200 Spectral lid, clear out
note from inside feeder, check reject tray for
note half rejected, close lid to clear error
3
Motor Stall
Open feeder lid, clear out notes from under
tongue, close lid to reset
3
1
PSU Voltage
Power supply is above or below the operational
range. Use power supply that meets the
requirements in
2
Note In Calibration Fail
Remove all notes from tray, clean lightpipe in
tray, power cycle to reattempt startup, if issue
persists return to nearest service centre
3
Note Out Calibration Fail
Remove all notes from tray, power cycle to
reattempt startup, if issue persists return to
nearest service centre
4
Note In Speed Fail
Remove all notes and power cycle to reattempt
calibration, if persists return
5
Note Out Speed Fail
Remove all notes and power cycle to reattempt
calibration, if issue persists return to nearest
service centre
4
2
EEProm Initialisation Fail
Return to nearest service centre
3
Download Fail
NV200 Spectral could not update BNF, power
cycle to reattempt download
8.3
Checking power connections to the unit
Check to ensure the power cables are correctly connected to the unit as shown in
the sections below.
