User Manual
–
NV200 Spectral
Copyright © Innovative Technology Ltd 2019
Doc: User Manual NV200 Spectral
Version: 2.1
Page 44 of
95
6
PROTOCOLS AND INTERFACING
6.1
Introduction
The NV200 Spectral supports standard industry protocols. Interfaces that are not
listed may be available upon request. For any queries regarding interfaces that are
not listed contact
support@innovative-technology.co.uk
Caution!
The use of an encrypted protocol
(preferable eSSP) is strongly
recommended to achieve the
highest security!
6.2
Interface Connectors
The NV200 Spectral validator has two connectors that are used to allow interfacing
and programming; these connectors are easily accessible at the back of the
validator.
Information
Power always required
regardless of connection
type.
Power is always required on pins 15(+V) and
16(0V) of the 16-way connector.
The first connector is a 16-pin socket used to interface the NV200 Spectral to the
host machine. The pin numbering of the socket is shown below, as well as an
overview of the socket connections:
When a Payout, Ticket Module or Docking Plate is connected a 16-pin Molex
0039012165 connector will replace the 16-pin Molex 9733272, the Pinout is below:
