User Manual
–
NV200 Spectral
Copyright © Innovative Technology Ltd 2019
Doc: User Manual NV200 Spectral
Version: 2.1
Page 67 of
95
8.3.3
Spectral Payout Connection
The Spectral Payout has a 16-pin molex
connector and a USB Type B socket.
These connectors are located on the
rear of the module at the bottom
8.3.4
Smart Ticket Connection
The SMART Ticket uses the same 16
pin molex connector as the Spectral
Payout, additional pins need to be
populated to carry communications to
both the NV200 Spectral and printer.
More details of this can be found in
An additional 4-pin molex connector is
required for power, both must be
connected before the unit will identify
as a Smart Ticket. When power is
supplied to the ticket the LED on the
rear will be illuminated.
8.3.5
Checking the Supply Voltage
If the power supply seems to be powered and connections to the unit are in place,
yet the unit isn’t powered, check the voltage output from the power supply is
sufficient and the polarity is correct. If this isn’t the issue replace the cable as it may
have been damaged. Should this not resolve the issue, contact your local repair
centre, details of which can be found on our website.
8.4
Communication with the Host
If there is no communication with the host check the communication cable, typically
this will be the IF17 and the port on the host system.
Ensure the cable is connected to the IF17 correctly, so the connectors are fully
seated, and the USB cable is connected to the computer.
