Smart Coin System User Manual
Page
9
of
28
Copyright © Innovative Technology Ltd 2015
GA02033
3.5.2
Flash Counts (Interface Type)
Flash Count
Flash Count
Interface
1 (Flashing Slow)
SSP
1 (Flashing Slow together) 1 (Flashing Slow together)
CC2
1 (Flashing Alternately)
1 (Flashing Alternately)
DES Trusted
Mode
The SMART Coin System leaves the factory pre-set to at least one currency and one
interface so that it is ready for immediate installation. The dataset and interface used
are shown on the label fixed to the back of the SMART Coin System.
3.5.3
DES Trusted Mode
When set to CC2 with DES enabled. DES trusted mode can be entered by resetting all
denomination levels to 0. On a power cycle the SMART Coin System will automatically
enter DES trusted mode for 2min to allow for pairing to the host. The easiest way to
set all levels to zero is to run an empty cycle.
3.5.4
Programming and Dataset loading
For programming and loading a new dataset in some cases it may be possible to
connect to the unit using the USB connectors on the SMART Coin System.
These connections are NOT for operational use. The 8 way connector should be used
at all times.
3.5.5
SD Card Update
Updating the SMART Coin System with a SD Card is a very quick and simple process.
You require a Class 4 SD Card.
A computer with a SD Card Reader
The card needs to be blank formatted in the FAT32 format.
Simply copy the Dataset/Firmware file on to the SD Card.
Then place the SD Card in to the SD slot on the front of the Smart Coin System.
During the update the LED lights will pulse at high speed. Once the update is
completed the SMART coin System will reset.
