Illustration 5
Step 3 Adjusting Friction Joints
Each joint on your new monitor arm has a built in set screw
that allows you to set the degree of friction and ease of
movement of that joint.
The friction joints are located (1) in the forearm, where the
tilter mechanism is inserted, (2) the forearm’s pivot point and
(3) mount base, where monitor arm is inserted.
See Illustration 6 on the next page.
INNOVATIVE OFFICE PRODUCTS, INC.
100 Kuebler Road
Easton, PA 18042
800-524-2744
sales@LCDARMS.com
1/4” Allen Wrench
Horizontal Position
Endcap
Mount
(1) Forearm
Illustration 6
All product returns require a Return Authorization (R/A)
Number. If you need to return your product for any reason,
please call 800-524-2744 to obtain your R/A or if you require
additional assistance with this product.
Model 9103
LCD Monitor Arm
Installation Instructions
Using the allen wrench in a horizontal position allows extra
leverage while adjusting.
Step 2 Setting the Counter-balance
Use the 1/4” allen wrench (provided), insert into the hole on the top
of the endcap with shaft; with one hand, hold the arm in a horizontal
position, while turning the allen wrench with the other hand to set
the weight adjustment. See Illustration 5 below.
To increase the weight for heavier monitors, turn
the wrench left (counter-clockwise).
To decrease the resistance for lighter monitors, turn the
wrench to the right (clockwise).
(2) Pivot Point
(3) Mount Base
© Innovative Office Products, Inc. 2003
IOP-502572
