1
WARNINGS
Before carrying out any installation or maintenance of the pHrx, disconnect it
from the mains power supply.
This appliance is not intended for use by persons (including children) that lack
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a responsible person.
The installation of this device should be carried out by a qualified person.
The pH
-
Basic device should be located in the correct pool zone and connected to
supply via a power outlet that is protected by a residual current device (RCD)
having a rated residual operating current not exceeding 30mA.
The power outlet should have a degree of protection suitable for the pool zone
Ensure that equipotential bonding of all parts of the pool installation is carried
out.
During the installation phase of the pHrx, check the following:
•
the voltage of the power supply must to the voltage indicated on the
side of the appliance
•
the injection point pressure must be lower than 1.5 Bar
•
the peristaltic pump's protection cover must be correctly fitted
•
the suction tube must be immersed in the corrective solution container
with the suction tube also connected to the peristaltic pump (left side).
•
the injection tube must be connected on one side to the peristaltic pump
(right side) and on the other side to the pool return pipe via the injection
valve.
Innowater Tratamientos Integrales del Agua S.L. will not be held liable for the
use of this device with inappropriate products.
