22
load. First axle of the tractor should always be loaded
with min.20% of the weight of the tractor itself. This is
very important specially on this machine because of its
distance between the tractor and working part of the
machine
Fig. 16
6. Adjustment and setting up
6.1 Regulation of the height of cut
Height of cut depends on working conditions and volume of the
material. The height of cut can be regulated with the hydraulic system on
the tractor or/and with adjusted rear roller of the machine
(Fig. 18).
The min. height of cut should be between 1-3 cm. The machine always
run on the rear roller and not on the skids.
Fig.17
1-3 cm
Summary of Contents for MKM
Page 33: ...33 Fig 33 Fig 34 Fig 37 Fig 38 1 Fig 34 6 Fig 35 Fig 36 Fig 38 2 5 9 4 10 7 8 3 1 2 ...
Page 38: ...38 A ...
Page 39: ...39 B ...