Version 1.0 09/08/2017
http://www.inorea.com
8
Process
Type
Explanation
Before
installation
Danger
★
When unpacking, if control system with water, parts missed or
component damaged are found, do not install!
★
If packing list does not match the real name, do not install!
★
Gently carry with care,otherwise there is the risk of damage to
equipment!
★
Please do not use the damaged driver or the frequency inverter
with missed pieces,otherwise there is the risk of injury!
★
Do not use your hand to touch the control system components,
otherwise there is the risk of electrostatic damage!
When installing
Danger
★
Please install the unit on the metal or flame retardant objects;
away from combustible material. Failure to do so may cause a fire!
★
Never twist the mounting bolts of the equipment components,
especially the bolt with the red mark!
Note
★
Do not let the lead wires or screws fall into the driver. Otherwise
which may cause damage to the driver!
★
Keep the driver installed in the place where less vibration, avoid
direct sunlight.
★
When two or more converters are installed in a cabinet, please pay
attention to the installation location, ensure the good heat
dissipation effect.
When wiring
Danger
★
Must comply with this manual's guidance,any construction shall be
performed by a professional electrician, otherwise there would be
the unexpected risk !
★
A circuit breaker must be set between the inverter and the power
supply to separate them, otherwise it may cause a fire!
★
Verify if power is a zero-energy status before wiring, otherwise
there is a risk of electric shock!
★
The inverter shall be grounded correctly according to standard
specifications, otherwise there is a danger of electrical shock!
★
Never connect the input power to the inverter output terminals
(U, V, W) . Note that the mark of the terminals, do not incorrectly
connect wires! Otherwise which may cause damage to the driver!