Version 1.0 09/08/2017
http://www.inorea.com
9
Process
Type
Explanation
★
Ensure that the distribution line meets the regional safety
standards of EMC requirements. The diameter of used wire shall
refer to the recommendations of this manual. Otherwise it may
cause an accident!
★
When connecting to braking resistor,the braking resistor must be
connected to position between terminals (P, RB) of the inverter
Before
energizing
Note
★
Please confirm whether the input power voltage is same as the
inverter rated voltage; wiring positions of power input terminals
(R,S,T) and output terminals (U,V,W) are correct or not; and note
that if there is a short circuit in the peripheral circuit connected to
driver,if the connected lines are tight, otherwise it may cause
damage to the driver!
★
Do not need to perform withstand voltage test for any part of the
inverter,this product has been tested before leaving factory.
Otherwise it may cause an accident!
Danger
★
The inverter's cover plate must close before power on. Otherwise
it may cause an electric shock!
★
Wiring of all external accessories must comply with the guidance
of this manual,please correctly wiring in accordance with the circuit
connection methods described in this manual. Otherwise it may
cause an accident!
After energizing
Danger
★
Do not open cover plate after energizing. Otherwise there is a risk
of electric shock!
★
Do not touch the driver and peripheral circuits with wet hands.
Otherwise there is a risk of electric shock!
★
Do not touch any input and output terminals of the inverter.
Otherwise there is a risk of electric shock!
★
The inverter automatically perform the safety testing for the
external strong electrical circuit in the early stages of energizing,
therefore never touch the driver terminals (U, V, W) or motor
terminals, otherwise there is a risk of electric shock!
★
If you need to identify the parameters, please pay attention to the
danger of injury during motor rotation. Otherwise it may cause an
accident!
★
Please do not change the inverter manufacturer parameters.