Version 1.0 09/08/2017
http://www.inorea.com
99
Besides, due to EEPROM is frequently stored, it will reduce the life of EEPROM, therefore
under the communication mode some function code do not need to be stored and you just
change the RAM value.
If F group parameters need to achieve the function, as long as change high order F of the
function code address to 0. If E group parameters need to achieve the function, as long as change
high order F of the function code address to 4. The corresponding function code addresses are
indicated below: high byte: 00 to 0F (F group), 40 to 4F (E group), 50 to 5F (B group), 60 to 67 (Y
group), low byte:00 to FF
For example:
Function code F3.01 can not be stored into EEPROM, address indicates as 0301; function
code E3.05 can not be stored into EEPROM, address indicates as 4305; the address indicates that
only writing RAM can be done and reading can not be done, when reading, it is invalid address.
For all parameters, you can also use the command code 07H to achieve the function.
Stop/Run parameters section:
Parameter address
Parameter description
1000H
*Communication set value (-10000 to 10000) (Decimal)
1001H
Set speed
1002H
Bus voltage
1003H
Output voltage
1004H
Output current
1005H
Output power
1006H
Output torque
1007H
Running speed
1008H
Terminal input flag status
1009H
Terminal output flag status
100AH
Analog AI1 value
100BH
Analog AI2 value
100CH
Reserved
100DH
Reserved
100EH
Reserved
100FH
Reserved
1010H
PID setting value